-
Introduction 0 hr 0 min
-
Hardware Target Configuration 0 hr 3 min
-
Preparing to Boot the Target 0 hr 2 min
-
Booting the Target with U-Boot 0 hr 4 min
-
Understanding the Source and Image Projects 0 hr 4 min
-
Building a VxWorks Source and Image Project 0 hr 5 min
-
Attaching Workbench to the Target 0 hr 2 min
-
Using VxSim from the Command Line Interface 0 hr 6 min
-
Using VxSim from Workbench 0 hr 6 min
-
Source Level Debugging with VxSim 0 hr 7 min
-
Quiz: Targets and Connections
-
Lab: Getting Started with VxWorks 0 hr 20 min
-
Lab Solution: Getting Started with VxWorks 0 hr 11 min
-
Ask an Expert
VxWorks 7: Targets and Connections
See how to use Workbench to build, run, and connect to your target.
Building an image and booting a target with it is a fundamental component of VxWorks development. This set of topics covers building images using source build (VSB) and kernel image (VIP) projects, booting into VxWorks with VxWorks and U-boot bootloaders, and configuring your bootloader to load your image and be prepared to connect to Workbench.
Product: VxWorks 7
Based on: SR540
Applicable for: All VxWorks 7